Abstract
Since considerable shrinkage stress develops during the curing of dental composites, various soft-start photocuring protocols, aiming to lower stress but not compromise conversion, have been proposed. We hypothesized that utilizing soft-start photocuring will result in not only reduced stress, but also decreased conversion. We evaluated the impact of 3 protocols (soft-start, pulse, and standard) on the stress development and polymerization extent of an experimental composite. A novel set-up capable of simultaneous shrinkage stress, conversion, and temperature measurements on the same specimen was utilized. Analysis of the data shows that stress rises dramatically as a function of conversion in the vitrified state, and the utilization of soft-start or pulse curing results in specimens with reduced final conversion and shrinkage stress, compared with specimens cured according to the standard full-intensity protocol. Finally, this study demonstrates that the predominant reason for the reduced shrinkage stress attained with soft-start or pulse curing is a modest decrease in final conversion.
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
