This paper presents an optimization of the mechanical properties of cement–Posidonia composite by means of experimental characterization. We are interested in producing composite of cement reinforced by Posidonia raw fibers. The ratio of fibers and water-to-cement mass is varied to determine its effect on the mechanical properties of the cement–Posidonia composite, particularly, its resistance to fracture. Three point bending and compression tests were carried out to study the mechanical properties of the composite. Scanning electron microscopy was used to examine the surface of the tested samples. The experimental investigation shows an improvement of flexural strength for a ratio W/C equal to 0.5 and fiber content equal to 10 vol%.
BoudouresqueCFBernardGBonhommeP. Preservation and conservation of Posidonia oceanica. RAMOGE2006, pp. 1–202. N°ISBN 2-905540-30-3.
2.
ZhijianLXungaiWLijingW. Properties of hemp fiber reinforced concrete composites. Compos Part A2006; 37: 497–505.
3.
SedanDPagnouxCSmithA. Mechanical properties of hemp fiber reinforced cement: Influence of the fiber/matrix interaction. J Eur Ceram Soc2008; 28: 183–192.
4.
CouttsRSP. Flax fibers as reinforcement in cement mortars. Int J Cem Compos Lightweight Concr1983; 5: 257–262.
5.
BilbaKArseneMAOuensangaA. Sugar cane bagasse fibre reinforced cement composites. Part I. Influence of the botanical components of bagasse on the setting of bagasse/cement composite. Cem Concr Compos2003; 25: 91–96.
6.
CookDJPamaRPWeerasingleHLSD. Coir fiber reinforced cement as a low cost roofing material. Building Environ1978; 13: 193–198.
7.
SavastanoHJrWardenPGCouttsRSP. Mechanically pulped sisal as reinforcement in cementitious matrices. Cem Concr Compos2003; 25: 311–319.
8.
Toledo FilhoRDJosephKGhavamiK. The use of sisal fiber as reinforcement in cement based composites. Rev Bras Eng Agríc Ambient1999; 3: 245–256.
9.
JodinP. Le Bois, Matériau d’Ingénierie, Nancy, France: Association pour la recherche sur le bois en Lorraine, 1994.
10.
RowellRMYoungRARowellJKRowellRM. Paper and composites from agro-based resources, Boca Raton, FL: Lewis Publishers, 1997.
11.
Garcia-Jaldon C. Morphological and chemical characterization of hemp (Cannabis sativa)/steam pretreatment and recovery. Thesis, University of Grenoble I, 1992.
12.
Garcia-JaldonCDupeyreMVignonMR. Fibres from semi-retted hemp bundles by steam explosion treatment. J Biomater Bioenergy1998; 14: 251–260.
13.
Sedan D. Study of physico-chemical interactions at interfaces hemp fiber/cement. Influence on the mechanical properties of the composite. Thesis, University of Limoges, Ceramic Materials and Surface Treatments, 2007.
14.
NcibiMCJeanne-RoseVMahjoubB. Preparation and characterization of raw chars and physically activated carbons derived from marine Posidonia oceanica (L.) fibers. J Hazard Mater2009; 165: 240–249.
15.
Denise CristinaONAiltonSFSergioNM. Studies on the characterization of piassava fibers and their epoxy composites. Compos Part A2012; 43: 353–362.
16.
SatyanarayanaKGSukumaranKMukherjeePS. Materials science of some lignocellulosic fibers. Metallography1986; 19: 389–400.
17.
LeeNJJangJ. The effect of fibre-content gradient on the mechanical properties of glass-fiber-mat/polypropylene composites. Compos Sci Technol2000; 60: 209–217.
18.
SwamyRNMangatPS. Influence of fiber geometry on the properties of steel fiber reinforced concrete. Cem Concr Res1974; 4: 451–465.
19.
NaamanAEMoavenzadehFMcGarryFJ. Probabilistic analysis of fiber reinforced concrete. J Eng Mech Div1974; 100: 397–413.
20.
RossiPHarroucheN. Mix design and mechanical behaviour of some steel-fibre material and structure. Mater Struct1990; 23: 256–266.
