The purpose of this study is to improve the potential energy recovery to electric energy in an electrohydraulic forklift system. The initial result achieved for the energy saving ratio after structural optimization is 40%. Component optimization is applied to the tested drive; this consists of an electric servomotor with direct torque control which is directly running a reversible hydraulic pump. According to the study, the energy efficiency and the energy recovery from the electrohydraulic forklift system can be increased by 11%. New ideas and directions for further research were obtained during the study.
ChiaraFCanovaM. A review of energy consumption, management, and recovery in automotive systems, with considerations of future trends. Proc IMechE Part D: J Automobile Engineering2013; 227(6): 914–936.
GaoY-JHuangRZhangQ. A comparison of three steering controllers for off-road vehicles. Proc IMechE Part D: J Automobile Engineering2008; 222(12): 2321–2336.
4.
MidgleyWJBCathcartHCebonD. Modelling of hydraulic regenerative braking systems for heavy vehicles. Proc IMechE Part D: J Automobile Engineering2013; 227(7): 1072–1084.
5.
KunzeG. Mobile construction machinery – trends and new developments, ATZonline, http://www.atzonline.com (April2010, accessed 10 January 2011).
6.
Diego-AyalaUMartinez-GonzalezPMcGlashanNPullenKR. The mechanical hybrid vehicle: an investigation of a flywheel-based vehicular regenerative energy capture system. Proc IMechE Part D: J Automobile Engineering2008; 222(11): 2087–2101.
7.
HoTHAhnKK. Design and control of a closed-loop hydraulic energy-regenerative system. Automn Constr2012; 22: 444–458.
8.
ZhangZChenJWuB. The control strategy of optimal brake energy recovery for a parallel hydraulic hybrid vehicle. Proc IMechE Part D: J Automobile Engineering2012; 226(11): 1445–1453.
9.
YeMBaiZ-FCaoB-G. Energy recovery for battery electric vehicles. Proc IMechE Part D: J Automobile Engineering2008; 222(10): 1827–1839.
10.
ZhangJLvCGouJKongD. Cooperative control of regenerative braking and hydraulic braking of an electrified passenger car. Proc IMechE Part D: J Automobile Engineering2012; 226(10): 1289–1302.
11.
Diego-AyalaUMartinez-GonzalezPMcGlashanNPullenKR, The mechanical hybrid vehicle: an investigation of a flywheel-based vehicular regenerative energy capture system. Proc IMechE Part D: J Automobile Engineering2008; 222(11): 2087–2101.
12.
AndersenTOHansenMRPedersenHCConradF. Regeneration of potential energy in hydraulic forklift truck. In: 6th international conference on fluid power transmission and control, Hangzhou, People’s Republic of China, 5–8 April 2005, pp. 302–306. Beijing: International Academic Publishers, World Publishing Corporation, 2006.
13.
MinavTLaurilaLImmonenP. Electric energy recovery system for a hydraulic forklift – theoretical and experimental evaluation. IET Electric Power Applic2011; 5(4): 377–385.
14.
HuiSJunqingJ. Research on the system configuration and energy control strategy for parallel hydraulic hybrid loader. Automn Constr2010; 19(2): 213–220.
15.
MinavT. Electric-drive-based control and electric energy regeneration in a hydraulic system. PhD Thesis, Acta Universitatis Lappeenrantaensis 436, Lappeenranta University of Technology, Lappeenranta, Finland, 2011.
16.
Budde-MeiwesHDrillkensJLunzB. A review of current automotive battery technology and future prospect. Proc IMechE Part D: J Automobile Engineering2013; 227(5): 761–776.
17.
MinavTLaurilaLPyrhönenJ. Permanent magnet synchronous machine sizing: effect on the energy efficiency of an electro-hydraulic forklift. IEEE Trans Ind Electron2012; 59(6): 2466–2474.
18.
AlibertMJGörlitzerHHerzogSNNeveuC D. Efficiency advantages in vane, piston and gear pumps – what high VI hydraulic fluids can do for you! In: 5th International Fluid POwr confrence, Dresden 2006, Germany, pp.211–225.
MinavTLaurilaLPyrhönenJ. Effect of electric motor on the energy efficiency of elecro-hydraulic forklift. In: MorvajZ (ed) Energy efficiency – a bridge to low carbon economy. Rijeka: InTech, 2012, ch 6.
24.
MerrittH. E.Hydraulic control systems. New York: John Wiley, 1967, p. 354.
25.
RahmfeldR. Development and control of energy saving hydraulic servo drives for mobile systems. PhD Thesis, Technical University of Hamburg-Harburg, Hamburg, Germany, 2002.
26.
PonomarevP. Tooth-coil permanent magnet synchronous machine design for special applications. PhD Thesis, Acta Universitatis Lappeenrantaensis 531, Lappeenranta University of Technology, Lappeenranta, Finland, 2013.
27.
AchtenPVaelGvan den BrinkT. Efficiency measurements of the hybrid motor/pump. In: 12th Scandinavian international conference on fluid power, Tampere, Finland, 18–20 May 2011, Vol. 3, pp. 41–49. Tampere: Tampere University of Technology.
28.
LiangXVirvaloT. What’s wrong with energy utilization in hydraulic cranes. In: 5th international conference on fluid power transmission and control, Hangzhou, People’s Republic of China, 3–5 April 2001, pp. 419–424. Beijing: International Academic Publishers, World Publishing Corporation.
29.
KarvonenMHeikkiläMHuovaM. Simulation study – improving efficiency in mobile boom by using digital hydraulic power management system. In: 12th Scandinavian international conference on fluid power, Tampere, Finland, 18–20 May 2011, Vol. 3, pp. 355–368. Tampere: Tampere University of Technology.
30.
LinjamaM. Digital fluid power-state of the art. In: 12th Scandinavian international conference on fluid power, Tampere, Finland, 18–20 May 2011, Vol. 4, pp. 331–354. Tampere: Tampere University of Technology.
AlibertMJDeneenDHHerzogSNNeveuCD. Impact of hydromechanical losses on hydraulic pump efficiency as a function of pressure, temperature and fluid viscometric properties. In: Society of Tribologists and Lubrication Engineers annual meeting and exhibition 2010, Las Vegas, Nevada, USA, 16–20 May 2010, pp. 293–295. Red Hook, New York: Curran Associates.
35.
MinavTASchimmelTPietolaM. Toward Better Energy Regeneration and Efficiency through Hydraulic Fluid Selection in an Electro-Hydraulic Forklift. The 9th International Fluid Power Conference, 9. IFK, March 24-26, 2014, Aachen, Germany. Aachen, Germany2014, pp.236-242.ISBN: 978-3-9816480-0-3.
36.
HamaguchiHOhkawaSPlacekDAlibertMJ. Hydraulic fluid influence on piston pump efficiency. In: 12th annual fuels and lubes Asia conference, Hong Kong, People's Republic of China, 1–3 March 2006. Hong Kong: F + L Asia, pp. 1-14.
37.
MinavTMurashkoKLaurilaLPyrhönenJ. Forklift with a lithium-titanate battery during a lifting/lowering cycle: analysis of the recuperation. Automation in Construction2013; 35: 275–284.
38.
RootM. The TAB battery book: an in-depth guide to construction, design and use. New York: McGraw-Hill, 2011, p.235.
39.
MinavTVirtanenALaurilaLPyrhönenJ. Storage of energy recovered from an industrial forklift. Automn Constr2012; 22: 506–515.
40.
GiulianoMRAdvaniSGPrasadAK. Thermal analysis and management of lithium-titanate batteries. J Power Sources, 2011; 196(15): 6517–6524.
41.
MajumdarSR. Oil hydraulic systems: principles and maintenance. New York: McGraw-Hill, 2002, p. 548.
