In this paper the hydromechanical deep drawing process was studied and the tensile instability in this process, and related critical fluid pressure, was discussed. In the theoretical approach, the formulation for the bulging and drawing stage of the process was obtained and the successful working zone was achieved. Also, the effect of geometrical and material properties on the pressure limits was studied. An experimental approach was used to determine the reliability of the theoretical study.
ZhangS. H.DanckertJ.Development of hydromechanical deep drawing. J. Mater. Process. Technol., 1998, 83, 14–25.
2.
YossifonS.TiroshJ.Rupture instability in hydroforming deep drawing process. Int. J. Mech. Sci., 1985, 27, 559–570.
3.
YossifonS.TiroshJ.On Suppression of plastic buckling in hydroforming deep drawing process. Int. J. Mech. Sci., 1985, 27, 177–185.
4.
YossifonS.TiroshJ.The maximum drawing ratio in hydroforming processes. Trans. ASME, J. Eng. Ind., 1990, 112, 47–56.
5.
TiroshJ.YossifonS.EshellR.BezterA.Hydroforming process for uniform wall thickness products. Trans. ASME, J. Eng. for Ind., 1977, 99, 685–691.
6.
LoS. W.HsuT. C.WilsonW. R. D.An analysis of the hemisphere punch hydroforming process. J. Mater. Processing Technol., 1992, 37, 225–239.
7.
HsuT. C.HsiehS. J.Theoretical and experimental analysis of failure for the hemisphere Punch hydroforming processes. Trans. ASME, J. Mf., Sci. Engng., 1996, 118, 434–438.
